Warehouse ❤️

Ice Machine

11.11.26 - Deep cleaned by Will King. Notes: I vacuumed the coils and tried out the coil comb on a few of the rough spots I could reach. Seemed to work well! I mainly followed the cleaning instructions listed on the inside of the machine. Ran both descaler/sanitizers and scrubbed all the surfaces I could reach. I disassembled the water distribution tube and cleaned it. The only thing I had trouble doing was cleaning the water trough. The bolts were very difficult to get to without disassembling the whole ice machine which I attempted to do, but had trouble getting the shell to budge. Also there's a copper thermometer w/ wiring attached to the trough that I didn't know how to go about removing, I didn't want to break it. The chemicals are supposed to do a good job of cleaning the trough, though and it didn't look too bad in there. There were some tiny rubber washers around the screws on the water distribution tube that crumbled when I removed them, not sure if that's a necessary replacement or not. I removed the ice bin door to clean and sanitize in the sink and it is now slightly filled up with sanitizer water.. whoops! I won't submerge those from now on.

Water Filters

10.16.26 - Will noted the CnC filter use counter seems to be busted (or at least not counting any water)

3.9.26 filter by ice machine replaced by Will, BestMax Premium XL

Red Diedrich Roaster (IR-12 I think)

3.3.26 - Jacob Bristol of Cold Spell got the roaster back up and running. I believe he deep deep cleaned it and then some spindle thing had to be replaced as well as a bearing. Notes from Jacob from Jan 2026 during the process: I’ve finally been halted during my epic 8 hour roaster cleaning flow state. The bottom fan and compartments all had half an inch of gunk on every inch but is now clean and spins freely and wonderfully. The front bearing is on and looks beautiful. 

The rear bearing is what’s stopping the party. It’s falling apart on itself and needs to be forced out with a bearing extractor. Y’all have a case for one! But the tool itself is missing… I’ll come back with one soon. Very soon if our local hardware store has one. 

Regardless, I knew I’d have to make another trip. It still needs plenty of cleaning in other, semi important compartments. Plus I’d like your roaster to be around for when it’s finished to go over everything.  I think invoice 000133 for $736.12 covers part/most of this.

Afinia Label Printer

4.2.25 - Gave error code “mech error 04”. After a lot of back and forth with tech support, determined that significant damage was caused due to a software update error. They put out an update that more or less broke the machine. New print head installed, deep cleaning of all valves performed… what else did I do… hard to remember. It took forever. Ava.